midi message

For the Voluum™ Digitally-Controlled Analogue Volume Effects Pedal

midi message

Postby Flop54 » Sun Jun 11, 2017 6:44 pm

Hye,

I have a question about controlling the wahoo and the voluum with a midi controller.
I need to do the same than the footswitch and the up and down buttons.

Is it possible?
Flop54
 
Posts: 109
Joined: Sat Apr 13, 2013 2:57 pm

Re: midi message

Postby james » Mon Jun 12, 2017 9:03 am

You can assign a MIDI controller to act as the "footswitch", but it will only control the effect on/off function of the footswitch. It won't control other special modes (long presses).

Up/down buttons can't be controlled directly, but you can easily select presets using MIDI program change. By default, each preset can be selected using it's number (00-99), with bank select used to switch between user (bank 0) and factory (bank 1) presets. If you use the new setlist feature you can assign any program numbers you like for your presets, which can make things a bit easier and more organised.
User avatar
james
Site Admin
 
Posts: 1794
Joined: Fri Jun 06, 2008 8:12 pm

Re: midi message

Postby Flop54 » Mon Jun 12, 2017 11:51 am

Thank you very much.

So what are the number off cc message to do that :

footswitch

and have you a message to this :

effect on
effect off?
Flop54
 
Posts: 109
Joined: Sat Apr 13, 2013 2:57 pm

Re: midi message

Postby james » Mon Jun 12, 2017 12:21 pm

By default, the CC used is #4 (footswitch) but you can change this using the editor to use any CC.

Effect on will occur when the CC value is >= 64.

Effect off will occur when the CC value is < 64.

Typically, you just sent values 0 and 127 to turn off and on.
User avatar
james
Site Admin
 
Posts: 1794
Joined: Fri Jun 06, 2008 8:12 pm

Re: midi message

Postby Flop54 » Mon Jun 12, 2017 12:57 pm

ok thank you.

It is not possible to have the same message to do on and off?
Flop54
 
Posts: 109
Joined: Sat Apr 13, 2013 2:57 pm

Re: midi message

Postby james » Mon Jun 12, 2017 2:23 pm

No, the same message can't be used to toggle the effect. The CC value needs to change.
User avatar
james
Site Admin
 
Posts: 1794
Joined: Fri Jun 06, 2008 8:12 pm

Re: midi message

Postby Flop54 » Mon Jun 12, 2017 5:53 pm

ok thank you
Flop54
 
Posts: 109
Joined: Sat Apr 13, 2013 2:57 pm


Return to Voluum™ Support

Who is online

Users browsing this forum: No registered users and 1 guest