MIDI Problems with Morningstar

For the Voluum™ Digitally-Controlled Analogue Volume Effects Pedal

MIDI Problems with Morningstar

Postby seanturland » Tue Dec 05, 2017 2:55 pm

Unfortunately my Voluum doesn't seem to be responding to any MIDI Program Change or CC messages coming from my Morningstar MC6.
Other pedals like the Strymon Big Sky are working perfectly with the MC6, and I don't have another device to test out but the Voluum used to respond to my DMC-3 before I sold it.
Any ideas what the problem could be?
Tried Omni and specific MIDI channels and there's just no response.
seanturland
 
Posts: 2
Joined: Thu Mar 10, 2016 5:18 pm

Re: MIDI Problems with Morningstar

Postby james » Tue Dec 05, 2017 3:31 pm

I don't know why it isn't working, but here's a few thoughts...

Bank select switches bank: 00 = factory presets; 01 = user presets.

Program number shown on the Voluum corresponds to the MIDI program number (F00 = 00, F01 = 01, etc). But if the MIDI numbers are numbered from 1, not 0, these will be offset by one: F00 = 01, F01 = 02, etc.

Are you using a setlist? A setlist gives you more control over the program numbers so that the MIDI program number doesn't need to match your preset number. Indeed, you can configure a setlist so MIDI program change has no effect.... so if using a setlist, check the "prog" setting for each "slot" to know what you should be sending for program change.
User avatar
james
Site Admin
 
Posts: 1794
Joined: Fri Jun 06, 2008 8:12 pm


Return to Voluum™ Support

Who is online

Users browsing this forum: No registered users and 1 guest

cron